Seca 703 User Manual download pdf (Page 25)

Model 703 25

7. What do I do if…

… no weight display comes on?

– Is the scale switched on?

– Check the batteries.

– Is the plug contact for connecting the display to the scale correctly connected?

… 0.00 does not appear before weighing?

– Switch off the scale with the Start key and start the scale again – there must not be

any load on the scale – and only its feet should be in contact with the floor.

… one segment is illuminated constantly or not at all?

– The relevant segment has a fault. Inform Servicing.

… the display shows ?

– Battery voltage is running low. Change the batteries in the next few days.

… bAtt appears in the display?

– Batteries are empty. Put in new batteries.

… St0p appears in the display?

– Maximum load has been exceeded.

… the display flashes?

– If you have just activated the Hold or Tare function, please wait until the scale has de-

tected a steady weight value. The display will then stop flashing.

– If there has been no activation of a function beforehand, remove the load from the scale

and wait until 0.00 is displayed, then weigh again.

… the display appears?

– The ambient temperature of the scale is too high or too low. Place the scale in an

ambient temperature between +10 °C and +40 °C. Wait about 15 minutes for the

scale to adapt to the ambient temperature and then weigh again.

… the display Er and a number appear (e.g. Er:0:12)?

– Switch off the scale with the Start key and start the scale again. The scale will then

work normally again.

If this is not the case, disconnect the power supply by briefly removing the batteries. If

this measure is equally unsuccessful, inform the Service department.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 101 102

No comments

Seca 703 User Manual Page 25