Seca 757 User Manual download pdf (Page 77)

What do I do if …? • 77

English

CAUTION!

Personal injury

If you notice any faults or deviations during the

function check which cannot be resolved with

the aid of the section entitled “What do I do if

...” in this document, you may not use the

device.

– Have the device repaired by seca service or

by an authorized service partner.

– Follow the section entitled “Servicing/

recalibration” in this document.

10.WHAT DO I DO IF …?

Fault Cause/Remedy

… no weight is dis-

played when scale is

loaded?

The scale is not connected to the power supply.

- Check if the scale is switched on.

- Check whether the battery block is inserted

and that the plug contacts are properly con-

nected.

… 0.000 does not appear

before weighing?

A load was placed on the scale before it was

switched on.

- Remove load.

- Switch scale off and back on again.

… a segment lights up

continuously or not at

all?

The relevant segment is faulty.

- Please notify maintenance service.

… is displayed?

Battery block power is running down.

- Charge battery block.

… the display “bAtt”

appears?

Battery block discharged.

- Charge battery block.

… the display “StOP”

appears?

The maximum load has been exceeded.

- Remove load.

… the display “tEMP”

appears?

The ambient temperature of the scale is too high

or too low.

- Set up scale in an ambient temperature

between +10 °C and +40 °C.

- Wait approx. 15 minutes until scale has

adjusted to ambient temperature.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 306 307

Comments to this Manuals

No comments