Seca 704 User Manual download pdf (Page 47)

100

101

Before you get started … • 47

English

5.2 Create power supply

Power is supplied to the scales either using batteries or

with a power supply unit available as an accessory.

Insert batteries You need 6 batteries, type AA (Mignon), 1.5 V (included

in scope of supply).

1. Press on latch of battery compartment.

2. Move down lid of battery compartment.

3. Remove battery holder.

4. Insert batteries in holder.

NOTE:

Observe correct polarity of batteries (markings

on battery holder). Should the display read

bAtt, you have inserted one of the batteries

incorrectly or they are flat.

5. Replace the holder with the batteries in the battery

compartment.

6. Close the battery compartment.

Connect the power

supply unit (optional)

The scales can be operated with a power supply unit

available as an accessory.

WARNING!

Personal injury and damage to device if

incorrect power supply unit is used

The voltage provided by standard power supply

units may be higher than their indicated rating.

This may cause the scales to overheat, catch

fire, melt or short-circuit.

– Only use genuine seca plug-in power supply

units with 9 V or a controlled 12 V output

voltage.

1. Insert the power plug necessary for your power

supply in the power supply unit.

2. Insert the connector plug of the power supply unit

in the connecting socket of the scales.

3. Plug the power supply unit into a mains socket.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 442 443

Comments to this Manuals

No comments

Seca 704 User Manual Page 47

Comments to this Manuals

Related products and manuals for Scales Seca 704